![]() ![]() The capture module page displays all currently running captures and allows starting new captures with specific filters. The capture module allows to configure filter for traffic that has not even started right now, for example for an IP address that is not in use at the moment but might be used later. ![]() These buttons allow capturing specific traffic, for example for a certain IP address or a network protocol. Capturing network traffic is usually started by clicking on a PCAP button in a certain module. In addition, it is also possible to capture network traffic to an attached storage device, see the settings section below for details. Traffic can be directly filtered for specific packets, only the relevant packets will be captured. No packet data is stored on the device itself. The Allegro Network Multimeter allows direct capturing of network traffic as a HTTP download to your computer. 1.3 Using expert filters to start captures.
0 Comments
Leave a Reply. |